EPICOL INJ LV
Low-viscosity epoxy resin for concrete injection.
EPICOL INJ LV is a low-viscosity epoxy resin for structural bonding of cracks and micro cracks in dry or wet concrete. EPICOL INJ LV can be used as glue for bonding and anchoring.
Good chemical resistance to alkalis, petroleum derivatives, acid, diluted organic acids, salts and solutions. For more information please contact RESIPLAST NV.
- For dry and wet applications
- Deep penetration in micro cracks
- Excellent adhesion to concrete
- Long processing time
Preparing the application surface
Make sure the surface is clean, repaired and sealed. The recommended processing temperature for the surface, the surroundings and the material is 15 to 25°C. Do not use below 10°C.
Stir the base (component A) evenly before use. Add the full amount of hardener (component B) and mix mechanically (300rev/min) until both components are homogeneous.
Injection in concrete
EPICOL INJ-LV is injected with a low pressure pump. Glue the injection packers on the crack and finish with a layer of EPICOL U. Alternatively use pre-drilled injection packers. The injection starts at the lowest point for vertical applications, and at the smallest crack for horizontal ones. Start the injection in the first nipple. Inject the crack until the resin reaches the next injection nipple and repeat this procedure for each nipple until the crack is completely filled. Never mix more resin than can be used within the pot life. Rinse the pump with SOLVENT MEK.
EPICOL INJ-LV is fully cured after one day and the injection nipples can be removed.
EPICOL INJ-LV is an excellent adhesive for gluing flat parts together. Apply EPICOL INJ LV with a brush on the flat parts. Press these together for 24 hours.
EPICOL INJ-LV can be mechanically loaded after 48 hours.
Malá Strana 234
742 01 Suchdol nad Odrou
firstname.lastname@example.orgMehr über das Unternehmen
Beratung und Umsetzung
Wir beraten unsere Stammkunden im Bereich Niederdruck- und Hochdruckverpressung.Mehr Informationen